Keysight N437 Series Programmer's Manual page 27

Property
UseElAdaptor
ElRcv1File
ElRcv2File
Property
ElSrc1File
ElSrc2File
CalSetUserCal
Keysight N437x Series Lightwave Component Analyzer, Programmer's Guide
Description
With this property you could switch the whole electrical path
deembedding on or off.
The name of the s2p file to use for electrical adaptor deembedding.
This property has to be used for receiver side deembedding in
single ended measurements or for the receiver port with the lower
number in differential measurements.
The name of the s2p file to use for electrical adaptor deembedding.
This property has to be used only for the receiver port with the
higher number in differential measurements.
Description
The name of the s2p file to use for electrical adaptor deembedding.
This property has to be used for source side deembedding in single
ended measurements or for the source port with the lower number
in differential measurements.
The name of the s2p file to use for electrical adaptor deembedding.
This property has to be used only for the source port with the higher
number in differential measurements.
Name a Calset on the network analyzer which has to be used for the
user calibration measurement.
If an empty string is passed, the current calset is used. If "NONE" is
passed, no calset is applied for the user calibration measurement.
Remote Operation
Type Default value
Boolean False
String Empty string
String Empty string
Type Default value
String Empty string
String Empty string
String Empty string
1
27