Keysight N437 Series Programmer's Manual page 50

1 Remote Operation
50
Command :PARameter:ELECtrical:PATH:DEEMbedding:75OHm
Syntax :PARameter:ELECtrical:PATH:DEEMbedding:75OHm
Description Specifies if components with 75 Ohm impedance are to be measured.
Parameters <string> 0 | 1 | ON | OFF
Response none
C# (property) LCAMeasParams.Imp75_Ohm
Example :PAR:ELEC:PATH:DEEM:75OH ON
Command :PARameter:ELECtrical:PATH:DEEMbedding:75OHm?
Syntax :PARameter:ELECtrical:PATH:DEEMbedding:75OHm?
Description Retrieves the property which defines whether components with 75 Ohm
impedance are to be measured.
Parameters none
Response <string> 0 | 1
C# (property) LCAMeasParams.Imp75_Ohm
Example :PAR:ELEC:PATH:DEEM:75OH? ? 1
Command :PARameter:ELECtrical:RECeiver:S2PFile[1 - 2]?
Syntax :PARameter:ELECtrical:RECeiver:S2P:FILE[1 - 2]:NAME?
Description Gets the name of the s2p file to use for electrical adaptor de-embedding.
File index 1 has to be used for receiver side de-embedding in single-ended
measurements or for the receiver port with the lower number in differential
measurements. Index 2 has to be used only for the receiver port with the
higher number in differential measurements
Parameters none
Response <string>
C# (property) ElRcv1File / ElRcv2File
Example :PAR:ELEC:REC:S2PFile? -> c:\temp\test.s2p
Keysight N437x Series Lightwave Component Analyzer, Programmer's Guide