Table of Contents
Advertisement
Keysight N437x Series Lightwave Component Analyzer, Programmer's Guide
OpticalInput As RemoteClient.EOpticalInput
Get or set the current optical input of the LCA testhead
Parameters
No parameters.
RFSwitchState
(ByVal RFSwitch As RemoteClient.ERFSwitch)
Setting the RF switches in the LCA testhead. With a non switched LCA
system, setting this property has no effect. Trying to set this property to
UnKnown, is ignored. Reading this property from a non switched system
will always return UnKnown.
Parameters
ByVak RFSwich As RemoteClient.ERFSwitch The switch you want to read
from or you want to set.
RFPowerFwd_dBm As Double
Gets or sets the RF power on the network analyzer ports for forward
measurements. To set this property back to the factory defined default
value, set it to Double.NaN or a value < - 200dBm.
Parameters
No parameters.
RFPowerRev_dBm As Double
Gets or sets the RF power on the network analyzer ports for reverse
measurements. To set this property back to the factory defined default
value, set it to Double.NaN or a value < - 200dBm.
Parameters
No parameters.
ReadOnly OpticalDCPower_dBm As Double
Get the actual optical DC power, measured by the optical powermeter
built into the LCA testhead
Parameters
No parameters.
Remote Operation
1
37
Advertisement
Table of Contents
