Asd Control Configuration - Toshiba ACE-tronics G9 ASD Installation And Operation Manual

ASD Control
Configuration
This parameter is used to set the operating mode
of the ASD. Selections are Standard Hoist
Control, Standard Traverse Control, and
Custom Control.
Standard Hoist Control
Select Standard Hoist Control to use the ASD for
Hoist Control and to place the following settings in
effect:
Closed-Loop Vector Control.
PG Feedback = On.
Torque Proving = Enabled.
1024 PG Pulse/Rotation.
PG Encoder Phase = 2.
PG Disconnection Detection = Enabled.
Control = 2-Step Variable.
I2 – I6 = Unassigned.
OUT1 = Brake Failure (154), N.O.
OUT2 = Brake Release (68), N.O.
BRAKE = Brake Release (68), N.O.
Express Stop = Disabled.
Plugging = Disabled.
Accel Time 1 = 3 Seconds.
Decel Time 1 = 1.5 Seconds.
Next = Go to Autotune Enable on pg.
Custom
Select Custom to use the ASD for application-specific Hoist Control or Traverse Control and to place the
Hoist
following associated settings in effect:
Hoist Control
Torque Proving = Enabled.
OUT1 = Brake Failure (154), N.O.
OUT2 = Brake Release (68), N.O.
BRAKE = Brake Release (68), N.O.
Traverse Control
Constant Torque.
Torque Proving = Disabled.
OUT1 = Fault All (10), N.C.
OUT2 = Always Off (254), N.O.
BRAKE = Brake Release (68), N.O.
Express Stop = Disabled.
ACE-tronics G9 ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
46.
Select Yes or No at Encoder Being Used?
Traverse
Next
Being Used?
Speed Sense
PG Feedback
Autotune
Pulses/Rotation
Encoder Phases
Disconnect
Detection
Select Standard Traverse Control to use the
Standard Traverse Control
ASD for Traverse Control and to place the
following settings in effect:
Constant Torque Control.
PG Feedback = Off.
Torque Proving = Disabled.
Control = 2-Step Variable.
I2 – I6 = Unassigned.
OUT1 = Fault All (10), N.C.
OUT2 = Always Off (254), N.O.
BRAKE = Brake Release (68), N.O.
Express Stop = Disabled.
Plugging = Disabled.
Accel Time 1 = 6 Seconds.
Decel Time 1 = 6 Seconds.
Next = Go to Autotune Enable on pg.
Encoder
No
Sensorless Vector
Off
Enabled
N/A
N/A
N/A
Go to Speed Control (F986) on pg.
46.
Yes
Closed Loop
On
Enabled
1024
2
Enabled
46.
45