Toshiba ACE-tronics G9 ASD Installation And Operation Manual page 154

F323
Drooping Insensitive Torque
Program  Feedback  Drooping Control
This parameter defines a torque range in which the Drooping Control settings
will be ignored and the programmed torque settings will be followed.
Drooping Output Filter
Program  Feedback  Drooping Control
This parameter is used to set the rate of output change allowed when operating
in the Drooping Control mode.
Jerky operation may be reduced by increasing this setting.
Express-Speed Selection
Program Crane/Hoist  Express Speed
This parameter enables the Express Speed function by selecting an operating
mode. The Express Speed function accelerates the output frequency of the
ASD from the programmed speed to the setting established in F330.
Select Off to disable the Express Speed feature.
Enabling the Express Speed function requires that an operating mode be
selected here, and that the criteria of parameters
Settings:
Off
Auto Speed (F-Motor: Up, R-Generator:Down)
Auto Speed (F-Generator: Down, R-Motor:Up)
F330 Setting (F-Motor: Up, R-Generator:Down)
F330 Setting (F-Generator: Down, R-Motor:Up)
Express Speed Setup and Run Criteria.
F328 = Off or Enabled.
If enabled, the following criteria must be met for Express Speed operation:
ASD output speed >
ASD output torque <
F331 and F335 condition exists for longer than
144
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
F331 – F333
F331 setting.
F335 setting.
F333
Direct Access Number — F323
Parameter Type — Numerical
Factory Default — 10.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 100.0
Units — %
Direct Access Number — F324
Parameter Type — Numerical
Factory Default — 100.0
Changeable During Run — Yes
Minimum — 0.1
Maximum — 200.0
Units — Radians/Second
Direct Access Number — F328
Parameter Type — Selection List
Factory Default — Off
Changeable During Run — Yes
be met.
setting.
ACE-tronics G9 ASD Installation and Operation Manual
F328