Autotune Enable; Speed Control (F986); Accel/Decel Times; Special Functions - Toshiba ACE-tronics G9 ASD Installation And Operation Manual

Autotune Enable

This parameter is used to enable/disable the
Autotune function.
Autotune 1 = Autotune Disabled or Enabled
Autotune on Run Command.

Speed Control (F986)

2-Step Variable
3-Step Variable
5-Speed —
F, R, and Preset Speeds 1 – 4.
2-Speed and 3-Speed
only the required number of Preset Speed settings.
Unipolar Analog
Bi-Polar Analog

Accel/Decel Times

Accel Time 1 = 10.0 S
Decel Time 1 = 10.0 S

Special Functions

Enable Slow-Speed Limit-Switch
Speed Limit Switch Reverse, respectively.
Enable Stop Limit-Switch
Limit-Switch Reverse, respectively.
Enable Express Speed (F328).
Enable (Plugging F494).
Creep Speed LL (F492) — Sets I4 to
Enable Super Creep
Enable Slack Rope Detection (F867).
Speed Reference
Enable Autotune On Run Command (F400).
Note: Enabling any of the above functions will overwrite the previous function assigned to
the associated discrete input terminal.
46
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
—
F, R, and I1.
—
F, R, I3 and I4.
—
Same as 5-Speed using
(RR).
(RX).
— Sets I3 and I4 to Slow-Speed Limit Switch Forward and Slow-
for F and R — Sets I5 and I6 to Stop Limit-Switch Forward and Stop
Creep Speed 1
— Sets I4 to Super Creep.
— Sets I4 to Frequency Reference Priority
Command.
Switching.
ACE-tronics G9 ASD Installation and Operation Manual