ABB REACT-3.6-TL Product Manual page 129

Inverter
tics > Statistics
onsumpti. > Lifetime
ufficien. > Partial
from grid > Today
to grid > Last 7 days
to load > Last 30 days
to load > Last 365 days
r. > User Period
gs > Settings
d 0000 Password 0000
me > Vstart
sh > Input mode
S485 com > Input UV Delay
y Select > Service
ssword > Remote ON/OFF
> MPPT Scan
*
ate Info > Power Limit.
Policy > Reactive Power
es > Autotest
> Alarms
> Backup
> Info
> Part No.
> Serial No.
> Firmware
We advise changing the activation voltage only if really necessary and
to set it to the correct value: the photovoltaic generator sizing tool availa-
ble on the ABB website will indicate whether Vstart needs changing and
what value to set it to.
Display
2. Input mode
This section of the menu allows you to set the input configuration mode.
> Settings
In particular:
• Independent. Independent configuration of the two input channels.
Password 0000
This configuration is set by default.
> Backlight
• Parallel. Parallel configuration of the input channels (single input chan-
nel). Other hardware settings must be set on the inverter to set this mode.
> Contrast
See the paragraph "Channel configuration in parallel mode"
> Buzzer
> Power Graph
3. Input UV Delay
This section of the menu allows you to set the time for which the inverter
> Language
stays connected to the grid after the input voltage has dropped below the
Under Voltage limit (set at 70% of Vstart).
This value can be set from 1 to 3600 seconds (60 seconds is the default
setting).
Example: With Input UV Delay set at 60 seconds, if voltage Vin drops be-
low 70% of Vstart at 9.00, the inverter stays connected to the grid (taking
power from it) until 9.01.
4. Service
This section of the menu is reserved for installers.
A special access password is required, which may be obtained from the
website https://registration.ABBsolarinverters.com.
Before connecting to the site, make sure you have all the information
required to calculate your password: Inverter Model, Serial Number and
**
week of manufacture of the Inverter
When you have a password you can set the parameters in the menu.
Changing the above-mentioned parameters may prevent disconnection
from the grid if the new values exceed those given in the standards of the
country of installation. If these parameters are changed to values outside
the standard range, an interface protection must be installed external to
the inverter in accordance with the requirements of the country of instal-
lation.
- 129 -
Скачано с сайта интернет магазина https://axiomplus.com.ua/
****
Meter
> Settings
Password 0000
> Meter model
> Meter Address
> Meter com
> Info
> Type
> Part No.
> Serial No.
> FW Rel.
> Measures
> Voltage
> Active Power
> Line current
> Load current
> Frequency
7 - Operation
****
Battery
> General
> Settings
Password 000
> Battery Mo
> Battery Pa
> Info
> Nom. Cap
> Measures
> Ibat
> Vbat
> Pbat
> RE
> SOC
> SOH
> RT
> Pack 1
> Statistics
> Energy disc
> E-day
> E-7d
> E-30d
> E-365
> E-tot
> Settings
Password 000
> Pack 1 ena
> Smoke Sens
> Info
> Device Nam
> Serial No.
> FW Rel.
> Nom. Capac