Table of Contents
Advertisement
Once the network has been created by the inverter, start up the connec-
tion and wait for the device to complete the procedure (a password is not
required for the Wi-Fi network).
The screens shown below pertain to a tablet with the Android operating system. Screens on
other devices or operating systems may differ.
• Open an internet browser and enter the pre-set IP address 192.168.117.1
to access the setup pages (web user interface)
A guided setup procedure will open that will enable you to impose the
necessary settings for correct commissioning of the REACT system.
The setup is broken down into 7 steps:
• Assisted setup - STEP 1
Settings of:
- menu language
- Time zone
- Grid standard
Each of the above-mentioned settings has a drop-down menu from which
preset parameters can be selected.
Press "Avanti" (Next) at the end of the settings to move on to setup step
2.
Setting the language refers to the webserver language, not the language of the display me-
nus on the REACT.
It might take several minutes to save the Grid Standard settings, then the inverter will carry
out a restart. Once the Grid Standard has been set it can be changed during the first 24 hours
of operation; after that time it will be necessary to obtain the second-level password to access
the "Inverter>Settings>Service> Reset Country S." menu.
Скачано с сайта интернет магазина https://axiomplus.com.ua/
ABB-123456-3N08-0115
- 110 -
7 - Operation
Advertisement
Table of Contents
