ABB REACT-3.6-TL Product Manual page 144

****
****
Meter Battery
> Settings > General
Password 0000 > Settings
> Meter model Password 0000
> Meter Address > Battery Model
> Meter com > Battery Packs
> Info > Info
> Type > Nom. Cap
> Part No. > Measures
> Serial No. > Ibat
> FW Rel. > Vbat
> Measures > Pbat
> Voltage > RE
> Active Power > SOC
> Line current > SOH
> Load current > RT
> Frequency > Pack 1
> Statistics
> Energy dischar.
> E-day
> E-7d
> E-30d
> E-365
> E-tot
> Settings
Password 0000
> Pack 1 enable
> Smoke Sensor
> Info
> Device Name
> Serial No.
> FW Rel.
> Nom. Capacity
> Init. Capacity
> Status
> Warning
> Alarms
> Measures
> Ibat
> Vbat
> Pbat
> Tbat
> FCC
> RC
> RE
> TED
> SOC
> SOH
> TUT
> TDT
> RT
> CC
2. Serial No.
Displays the serial number of battery pack 1 connected to the REACT
system
****
Load Manager WIFI Logger
3. FW Rel.
Displays the revision of the firmware installed on the REACT-BATT.
> info > Settings
> Relay Status > Restore AP
4. Nom. Capacity
> Info
> Part No.
Displays the nominal capacity of battery pack 1 connected to the system.
> Serial No.
> View IP
5. Init. Capacity
> View Mode
Displays the value of the initial capacity of battery pack 1.
6. Status
Displays the operating status of the battery pack from the following:
- Stand-by
- Sleep
- Run
- Warning
- Fault 1
- Fault 2
- Other fault
- Emergency
- Wait black start
- Disabled
7. Warning
Displays details of the warning detected by the REACT-BATT
8. Alarm
Displays details of Fault 1 and Fault 2 detected by the REACT-BATT
Battery > Pack 1 > Measure
Select the Measure menu to access the following sub-menus:
1. Ibat
Battery pack 1 current value
2. Vbat
Battery pack 1 voltage value
3. Pbat
Battery pack 1 instantaneous power value
4. Tbat
Battery pack 1 temperature value
5. FCC
Full charge capacity - Current capacity of battery pack. This value is con-
tinuously updated based on the operation of the storage system.
- 144 -
Скачано с сайта интернет магазина https://axiomplus.com.ua/
7 - Operation