Understanding External Shunt Module Connections - Rockwell Automation Allen-Bradley Kinetix 6000 User Manual

Understanding External
Shunt Module Connections
This Shunt Module Cat. No.
Power rail mounted
2094-BSP2
shunt module.
External passive shunt
connected to the
1394-SRxxxx
power rail shunt
module.
External active shunt
connected to the dc 1336-MOD-Kxxxx
bus.
Follow these guidelines when wiring your external active or passive
shunt resistor kit.
When tightening screws to secure the wires, refer to the tables
IMPORTANT
beginning on page 80 for torque values.
To ensure system performance, run wires and cables in the
IMPORTANT
wireways as established in Chapter 2.
Shunt Module Wiring
With This Module Do This
• Verify the internal shunt jumper is in place between RC-2 and RC-3, as
shown in the figure below.
N/A
• Verify the thermal switch jumper is in place between TS-1 and TS-2, as
shown in the figure below.
• Remove the internal shunt jumper between RC-2 and RC-3.
• Remove the thermal switch jumper between TS-1 and TS-2
(if your shunt module includes a thermal switch).
SM
• Refer to External Shunt Resistor on page 40 and Mounting the External
2094-BSP2
Shunt Module on page 48.
• Refer to Locating Shunt Module Connectors and Indicators on page 68.
• Refer to Shunt Module Wiring Examples on page 201.
• Refer to External Shunt Resistor on page 40.
• Refer to Shunt Module Wiring Examples on page 201.
IAM
2094-xCxx-Mxx
• Refer to the installation instructions provided with your Bulletin 1336 shunt
module, publication 1336-5.64.
Shunt Module Jumper Settings
Shunt Module, Top View
Cable Shield
(2094-BSP2)
Clamp
External Shunt Resistor
(RC) Connector
External Thermal Switch
(TS) Connector
(1)
These are the default jumper settings.
Connecting the Kinetix 6000 Drive System
COL
INT
DC+
TS2
TS1
COL
INT
DC+
TS2
TS1
Publication 2094-UM001A-EN-P — September 2006
113
(1)
Jumper