Removing And Replacing The Kinetix 6000 Drive Modules; Introduction; Before You Begin - Rockwell Automation Allen-Bradley Kinetix 6000 User Manual

Introduction

Before You Begin

163
Removing and Replacing the Kinetix 6000
Drive Modules
This chapter provides remove and replace procedures for your
Kinetix 6000 system components.
Topic
Introduction
Before You Begin
Removing Power Rail Modules
Replacing Power Rail Modules
Removing the Power Rail
Replacing the Power Rail
This drive contains ESD (Electrostatic Discharge) sensitive parts
ATTENTION
and assemblies. You are required to follow static control
precautions when you install, test, service, or repair this
assembly. If you do not follow ESD control procedures,
components can be damaged. If you are not familiar with static
control procedures, refer to Allen-Bradley publication
8000-4.5.2, Guarding Against Electrostatic Damage or any other
applicable ESD Protection Handbook.
You will need the following tools available before you begin removal
and replacement procedures:
•
A flat blade screw driver
•
A small flat blade screw driver, 3.5 mm (0.14 in.)
•
Voltmeter
Chapter
Publication 2094-UM001A-EN-P — September 2006
8
Page
163
163
164
165
166
167