System Upgrade - Polycom RSS 4000 User Manual

Chapter 4 - Administrator Configuration
1
2
3


System Upgrade

1
2
4-48
Archives Backup
You need to set a backup path in the Media Back Path field on the page
before archives backup.
There are two ways to backup archives on Polycom® RSS™ 4000 to an FTP
server: automatic periodic backup and full manual backup. The files which
have been backed up will not be backed up again, unless full manual backup
is conducted.
If the Auto remove after backup is successfully completed option at the
bottom of the page is selected, then the recorded files will be automatically
deleted from system after backup.
To automatically back up archives:
Select Enable automatic backup in the Media Backup Configuration
area to enable the automatic backup function.
Set following parameters:
Table 4-42 Description of Automatic Backup Parameters
Parameter
Frequency
Start Time
Click Update to apply these settings.
To manually back up the archives:
Click Full Media Backup in the ACTIONS area on the Data
Backup/Restore page.
Backup/Restore Status on the page shows the number of files being and
have backed up. When a message pops up at the right bottom of the page
prompting you for successful backup, the files backup has completed.
You can upgrade the software version of the system on the System Upgrade
page. Click Admin>System Upgrade in the menu at the top of the page to
enter the System Upgrade page. Upgrading the software of Polycom® RSS™
4000 system needs the activation key corresponding to the upgrade pack
version. Different software upgrade pack versions may require different
activation keys.
To upgrade from Version 6.x to Version 7.0
To upgrade the system from V6.x to V7.0, you need to complete the
following two procedures:
Install Version 7.0 upgrade pack on the system
Activate the upgraded system
Description
Select the period for automatic backup, measured in day.
Select the start time of automatic backup.
Polycom, Inc.