Polycom RSS 4000 User Manual page 100

Chapter 6 – Appendix A – Telnet/Terminal Commands
Network Setting
Enter the following commands after the prompt "#" to set network
configurations:
"set {lan1 | lan2} ip {dhcp | static <ip> netmask <mask> gw <gateway>}" -
set the IP address for LAN 1 or LAN 2.
"set {lan1 | lan2} speed {auto | 1000 | 100 full | 100 half | 10 full | 10 half}"
- set the connection features for the LAN 1 or LAN2 interface.
Table 6-49
Table 6-50
[Example 1] Set the IP address of the LAN1 interface to 172.21.103.29, subnet
mask to 255.255.255.0, and the gateway address to 172.21.103.254:
6-6
Network Setting Parameters – LAN Interface IP Address
Parameter Description
Automatically gets the address information through the DHCP
dhcp
server.
Specifies the static IP address information -
Ip: IP address of the network port
static
mask: subnet mask of the network port
gateway: gateway address of the network port
Network Setting Parameters – LAN Interface Connection Rate
Parameter Description
auto Auto negotiation mode
1000 1000Mbps
100 full 100Mbps full duplex
100 half 100Mbps half duplex
10 full 10Mbps full duplex
10 half 10Mbps half duplex
Polycom, Inc.