Sip - Polycom RSS 4000 User Manual

Parameter
Gatekeeper User
Gatekeeper Password
System Prefix/E164.
System H.323Alias
3

SIP

If your network supports the Session Initiation Protocol (SIP), you can use
SIP to connect IP calls. The Polycom® RSS™ 4000 system supports only the
integration with Polycom DMA SIP server.
To configure the SIP settings:
1
2
Table 4-24
Parameter
Enable SIP
Transport Type
Register to SIP Server
SIP Server
Register User Information
Outbound Proxy Server
3
Polycom, Inc.
Description
Specifies the user name for registration with Polycom DMA
server.
Specifies the password for registration with Polycom DMA
server.
Specifies the E.164 number for the system.
Specifies the H.323 alias for the system.
Click Update and confirm to restart the system to apply the setting.
Click System Config>Signaling Setting>SIP in the menu bar at the top
of the page.
Set the following parameters in the SIP page:
SIP Parameters Description
Click Update and confirm to restart the system to apply the setting.
Charpter 4 - Administrator Configuration
Description
Specifies whether to enable the SIP in the system. You
need to set the SIP server-related parameters after this
function is enabled.
Specifies the transport layer protocol used for
communicating with the SIP server. It needs to be
consistent with the protocol supported by the SIP server.
Specifies whether to register the system to the Polycom
DMA SIP server.
Specifies the IP address, connection port, and domain
name of the SIP server for registration service.
Specifies the user name and password that authenticates
the system to the SIP Server.
For communication with the SIP server when the system
is configured on the internal network, an outbound proxy
server is required to implement traversal of the firewall or
NAT. In this case, you need to set the IP address and port
number for the outbound proxy server.
4-19