Appendix A - Telnet/Terminal Commands; Hyperterminal Parameters; Login - Polycom RSS 4000 User Manual

Appendix A – Telnet/Terminal
Commands
Polycom® RSS™ 4000 supports device debugging from the command line.
You can configure command settings in either of the following two methods:
using the HyperTerminal after connecting it to the device through a serial
port or configuring via telnet. Both methods use the same command format.
Next, we will describe how to configure command setting using the
HyperTerminal.

HyperTerminal Parameters

•
•
•
•
•
Furthermore, you may need to set some other parameters based on the
simulation software used:
•
•
•
•

Login

If you have completed all the above configurations and launched the
HyperTerminal simulation software successfully, press the Enter key. The
login interface appears.
Polycom, Inc.
Port: COM1 (basing on the port used)
Baud rate: 115,200 bps
Data bits: 8 bits
Parity bit: None
Stop bit: 1
No echo for local input
The settings for the DEL and Backspace keys
Enter/New line
The simulation type for the endpoint: Automatic or ANSI
6
6-1