Polycom RSS 4000 User Manual page 98

Chapter 6 – Appendix A – Telnet/Terminal Commands
•
The system will show the prompt message "Are you sure?". Type "Y" to
proceed, or type "N" to cancel.
After resetting the system configuration, the system must be restarted in
order for the new settings to take effect.
Clean Activation Key
Type "cleankey" after the prompt "#" to remove the existing activation key.
This command is used to deactivate the RSS™ 4000 system.
The system will show the prompt message "Are you sure?". Type "Y" to
proceed, or type "N" to cancel.
Telnet Setting
Type "telnet {on | off}" after the prompt "#" to turn on/off the telnet session.
For example, enter "telnet on" to enable telnet function.
Password Modification
Type "set telnet password" after the prompt "#" to modify the login
password for the Command Setting page.
This command is only used to change the login password for the telnet
session and serial interface. It does not impact the Web UI password.
6-4
― Service Setting
― Signaling Setting
Admin
― UI Customization (System name and default endpoint menu
language)
― Disk Warning
If you need to completely restore the system please refer to Restoring Factory Default
Configuration.
The default setting is telnet on. If "telnet off" is entered to disable the telnet function of
the Polycom ® RSS™ 4000, user can only use the serial port to perform above
system setting tasks. The default telnet port is 23, which cannot be modified. The
password and command operations for remote telnet login are identical to those for
serial port login.
Polycom, Inc.