Swing Wall Assembly - KidKraft NEWPORT PLAYSET F29015 Installation And Operating Instructions Manual

Step 6: Swing Wall Assembly
Part 1
A: Attach (1928) Lower Side, noticing the side the bolt hole on the extended end is on, using 4 (H2) 1/4 x 2" Hex
Bolts (with lock washer, flat washer and t-nut); (1924) SW Floor (in the bottom holes) and (1925) SW Top using 2
(H2) 1/4 x 2" Hex Bolts (with lock washer, flat washer and t-nut) for each board to 2 (1500) Posts. (fig. 6.1)
Note: Keep all bolts loose.
B: On the side indicated in fig. 6.1, attach (0369) Lower Diagonal to (1928) Lower Side with 1 (H2) 1/4 x 2" Hex
Bolt (with lock washer, flat washer and t-nut).
Fig. 6.1
Notice the hole
locations of (1924)
SW Floor.
Notice bolt holes
on this side
Wood Parts
1 x SW Floor 1 x 6 x 26-7/8"
1924
1 x SW Top 1 x 4 x 36"
1925
1 x Lower Side 1 x 5 x 59-11/16"
1928
1 x Lower Diagonal 2 x 3 x 37"
0369
2 x Post 2 x 4 x 83"
1500
1/4"
T-Nut
1/4" Flat
Washer
1/4" Lock
Washer
0369
1/4"
T-Nut
H2
1500
H2
H2
Hardware
9 x H2 1/4 x 2" Hex Bolts
(1/4" lock washer, 1/4" flat washer and 1/4" t-nut)
19
1925
1924
1928
Step 6 Part 1
europecustomerservice@kidkraft.com