Swing Wall Assembly - KidKraft WINDALE Installation And Operating Instructions Manual

Step 8: Swing Wall Assembly
A: Loosely attach (2223) SW Ground using 4 (H2) 1/4 x 2" Hex Bolts (with lock washer, flat washer and t-nut);
(2211) Floor End (in the top holes); (2224) SW Side and (1935) Side Roof using 2 (H2) 1/4 x 2" Hex Bolts (with
lock washer, flat washer and t-nut) for each board to 2 (2215) Posts. (fig. 8.1) Note: Keep all bolts loose.
B: Place (2228) Wall Mount across (2211) Floor End, (2224) SW Side and (1935) Side Roof then attach using 3
(G4) 5/16 x 4" Hex Bolts (with lock washer, flat washer and t-nut) as shown in fig. 8.1. Notice the side holes are
towards the top of the board.
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
C: Make sure assembly is square and then fasten (2211) Floor End to (2215) Posts using 2 (LS1) 1/4 x 1-1/2"
Assemble Left Wall
Lag Screws (with flat washer). (fig. 8.1) Tighten all (H2) 1/4 x 2" Hex Bolts.
Fig. 8.1
Notice shorter end on
this side and angle
facing up.
2223
Wood Parts
1 x Floor End 1 x 5 x 35-1/4"
2211
1 x Side Roof 1 x 4 x 55-1/8"
1935
2 x Post 2 x 4 x 84-3/8"
2215
1 x Wall Mount 2 x 4 x 38-1/4"
2228
1 x SW Ground 1 x 5 x 74"
2223
1 x SW Side 1 x 4 x 35-7/8"
2224
Notice the hole
locations in (2228)
Wall Mount
H2
5/16"
2224
t-nut
H2
2211
1/4" flat
washer
H2
LS1
2215
10 x
3 x
2 x
1935
G4
1/4"
t-nut
5/16" flat
washer
2228
5/16" lock
washer
1/4" 1/4" flat
t-nut washer
H2
Hardware
1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
H2
5/16 x 4" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
G4
1/4 x 1-1/2" Lag Screw (1/4" flat washer)
LS1
24
H2
1/4" flat
washer
1/4" lock
washer
H2
LS1
Notice the pilot hole
locations towards
bottom of board
G4
2215
1/4" lock
washer