Parameter Set-Up; Quick Menu Key Functions - Danfoss FC 300 Programming Manual

2. How to Programme
Status screen II:
See the operating variables (1.1, 1.2, 1.3 and 2) shown in the screen in
this illustration.
In the example, Speed, Motor current, Motor power and Frequency are
selected as variables in the first and second.
2
Status screen III:
This state displays the event and action of the Smart Logic Control. For
further information, see section

2.1.6. Parameter Set-Up

The frequency converter can be used for practically all assignments, which is why the number of parameters is quite large. The frequency converter offers
a choice between two programming modes - a Main Menu and a Quick Menu mode.
The former provides access to all parameters. The latter takes the user through a few parameters making it possible to start operating the frequency
converter.
Regardless of the mode of programming, you can change a parameter both in the Main Menu mode and in the Quick Menu mode.

2.1.7. Quick Menu Key Functions

Pressing [Quick Menus] The list indicates the different areas contained in
the Quick menu.
My Personal Menu
Select
These parameters are selected in par. 0-25
ferent parameters can be added in this menu.
Quick setup
Select to go through a limited amount of parameters to get the motor running almost optimally. The default setting for the other parameters
considers the desired control functions and the configuration of signal inputs/outputs (control terminals).
The selection of parameter is effected by means of the arrow keys. The parameters in the following table are accessible.
16
Smart Logic Control
.
to display the chosen personal parameters.
Personal Menu
. Up to 20 dif-
MG.33.M3.02 - VLT
1.1
®
is a registered Danfoss trademark
FC 300 Programming Guide
1.3
1.2
2