Danfoss FC 300 Programming Manual page 36

2. How to Programme
[180] HP
0-31 Custom Readout Min Value
Range:
0.00 [0 - par. 0 - 32]
2
0-32 Custom Readout Max Value
Range:
*
100.00 [Par. 0-31 - 999999.99 ]
2.3.6. LCP Keypad, 0-4*
Enable, disable and password protect individual keys on the LCP keypad.
0-40 [Hand on] Key on LCP
Option:
[0] Disabled
* Enabled
[1]
[2] Password
0-41 [Off] Key on LCP
Option:
[0] Disabled
*
Enabled
[1]
[2] Password
0-42 [Auto on] Key on LCP
Option:
[0] Disabled
* Enabled
[1]
[2] Password
0-43 [Reset] Key on LCP
Option:
[0] Disabled
* Enabled
[1]
[2] Password
36
Function:
This parameter sets the min. value of the custom defined readout (occurs at zero speed). Only possible to set
different from 0 is when selecting a linear unit in
the minimum value will be 0.
Function:
This parameter sets the max value to be shown when the speed of the motor has reached the set value for
Speed High Limit
, (par.4-13/4-14).
Function:
No function
[Hand on] Key enabled
Avoid unauthorized start in Hand mode. If par. 0-40 is included in the My Personal Menu, then define the
par. 0-65 Personal Menu Password
password in
word
.
Function:
Avoids accidental stop of the frequency converter.
Avoids unauthorised stop. If par. 0-41 is included in the Quick Menu, then define the password in par. 0-65
Quick Menu Password .
Function:
avoid accidental start of the frequency converter in Auto mode.
Avoids unauthorised start in Auto mode. If par. 0-42 is included in the Quick Menu, then define the password
Quick Menu Password
in par. 0-65 .
Function:
Avoids accidental alarm reset.
Avoids unauthorised resetting. If par. 0-43 is included in the Quick Menu, then define the password in par. 0-65
Quick Menu Password
.
®
MG.33.M3.02 - VLT is a registered Danfoss trademark
FC 300 Programming Guide
Custom Readout Unit , par. 0-30. For Quadratic and Cubic units
par. 0-60 Main Menu Pass-
. Otherwise define the password in
Motor