Danfoss FC 300 Programming Manual page 25

FC 300 Programming Guide
2.2. Parameter Selection
Parameters for FC 300 are grouped into various parameter groups for easy selection of the correct parameters for optimized operation of the frequency
converter.
0-xx Operation and Display parameters
• Basic Settings, set-up handling
• Display and Local Control Panel parameters for choosing readouts, setting up selections and copying functions
1-xx Load and Motor parameters includes all load and motor related parameters
2-xx Brake parameters
• DC brake
• Dynamic brake (Resistor brake)
• Mechanical brake
• Over Voltage Control
3-xx References and ramping parameters includes DigiPot function
4-xx Limits Warnings; setting of limits and warning parameters
5-xx Digital inputs and outputs includes relay controls
6-xx Analog inputs and outputs
7-xx Controls; Setting parameters for speed and process controls
8-xx Communication and option parameters for setting of FC RS485 and FC USB port parameters.
9-xx Profibus parameters
10-xx DeviceNet and CAN Fieldbus parameters
13-xx Smart Logic Control parameters
14-xx Special function parameters
15-xx Drive information parameters
16-xx Read out parameters
17-xx Encoder Option parameters
®
MG.33.M3.02 - VLT is a registered Danfoss trademark
2. How to Programme
25
2