Danfoss FC 300 Programming Manual page 17

FC 300 Programming Guide
Parameter Designation
0-01 Language
1-20 Motor Power
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
5-12 Terminal 27 Digital Input
1-29 Automatic Motor Adaptation (AMA)
3-02 Min Reference
3-03 Max Reference
3-41 Ramp 1 Ramp-up Time
3-42 Ramp 1 Ramp-down Time
3-13 Reference Site
* If terminal 27 is set to "no function", no connection to +24 V on terminal 27 is necessary.
Select Changes made to get information about:
• the last 10 changes. Use the [▲] [▼] navigation keys to scroll
between the last 10 changed parameters.
• the changes made since default setting.
Select
information is shown as graphs.
Only display parameters selected in par. 0-20 and par. 0-24 can be
viewed. It is possible to store up to 120 samples in the memory for later
reference.
®
MG.33.M3.02 - VLT is a registered Danfoss trademark
2. How to Programme
Setting
[kW]
[V]
[Hz]
[A]
[rpm]
[0] No function*
[1] Enable complete AMA
[rpm]
[rpm]
[sec]
[sec]
Loggings to get information about the display line read-outs. The
2
17