AS-i 3.0 PROFINET Gateway with integr. Safety Monitor
Appendix, Examples
19.1.2
Setting in the NC control
The "PROFISAFE_MASTER_ADDRESS" is taken from the hardware configura-
tion (F_Source_Address) and entered in number 10385.
Example:
10385
7D2
19.1.3
Setting "PROFISAFE_IN_ADDRESS"
The "PROFISAFE_IN_ADDRESS" must be set in two 32-bit fields so that the 64-
bit Gateway input data can be addressed.
Example:
10386[0] 050000CA (corresponds to 202 decimal, from the hardware configuration,
10386[1] 050100CA (corresponds to 202 decimal, from the hardware configuration,
19.1.4
Setting "PROFISAFE_OUT_ADDRESS"
The
"PROFISAFE_OUT_ADDRESS"
"PROFISAFE_IN_ADDRESS" so that all 64 bits can also be addressed here.
Example:
10387[0] 050000CA (corresponds to 202 decimal, from the hardware configuration,
10387[1] 050100CA (corresponds to 202 decimal, from the hardware configuration,
19.1.5
Setting "PROFISAFE_IN_ASSIGN"
Here you enter in which data range the safe input bits are entered in the INSE.
Example:
10388[0] 001032
10388[1] 033064
(corresponds to 2002 decimal)
F-destination address, the 5 at the beginning stands for Profi-
bus, addresses the first 32 bits of the input data).
F-destination address, the 5 at the beginning stands for Profi-
bus, addresses bits 33-64 of the input data).
must
F-destination address, the 5 at the beginning stands for Profi-
bus, addresses the first 32 bits of the output data)
F-destination address, the 5 at the beginning stands for Profi-
bus, addresses bits 33-64 of the output data).
(The first 32 bits are mapped from 1 to 32).
(The next 32 bits are mapped from 33 to 64).
be
set
analogous
to
the
121