Sense Subsystem - Agilent Technologies EMC Series Programmer's Manual

Spectrum analyzers 9 khz-1.5/3.0/6.7/13.2/26.5 ghz

Hide thumbs Also See for EMC Series:

Language Reference

SENSe Subsystem

Sets the instrument state parameters so that you can measure the input signal.

SENSe subsystem commands used for measurements in the

menus may only be used to set parameters of a specific measurement when

the measurement is active. Otherwise, an error will occur. You must first select the

appropriate measurement using the :CONFigure:<measurement> command.

If a :SENSe command is used to change a parameter during a measurement

(while not in its idle state), the measurement will be restarted.

E7404a E7402a E7405a E7401a E7403a