Advertisement
Front Panel
Access:
Normalized Reference Level
:DISPlay:WINDow:TRACe:Y[:SCALe]:NRLevel <rel_ampl>
:DISPlay:WINDow:TRACe:Y[:SCALe]:NRLevel?
Sets the normalized reference level.
See command :CALCulate:NTData[STATe] OFF|ON|0|1
NOTE
Factory Preset
and *RST:
Range:
Default Unit:
Front Panel
Access:
Normalized Reference Level Position
:DISPlay:WINDow:TRACe:Y[:SCALe]:NRPosition <integer>
:DISPlay:WINDow:TRACe:Y[:SCALe]:NRPosition?
Selects the position of the normalized reference level. The top and bottom graticule
lines correspond to 10 and 0, respectively.
NOTE
See command :CALCulate:NTData[STATe] OFF|ON|0|1
Factory Preset
and *RST:
Range:
Front Panel
Access:
Chapter 5
is not set above the reference level and the reference is set so
that the signal is within the display range. When in fixed mode
the measurement has approximately 70 dB of display range.
AMPLITUDE/Y Scale, IF Gain Auto Fixed
is available with firmware revision A.06.00 and later).
0 dB
–327.6 to 327.6 dB
Current active units
View/Trace, Normalize, Norm Ref Lvl
10
integer
View/Trace, Normalize, Norm Ref Posn
Language Reference
DISPlay Subsystem
(front panel access
239
Advertisement
