Specify Signal List Display Parameters - Agilent Technologies EMC Series Programmer's Manual

Language Reference
CALCulate:EMI:SLISt Subsection

Specify Signal List Display Parameters

:CALCulate:EMI:SLISt:View
COMMent|PEAK|QPEak|AVERage
:CALCulate:EMI:SLISt:View?
Specifies the signal display parameters given by the following:
COMM - Displays the comment for each of the signals in the list.
PEAK - Displays the difference values, in dB, from the measured peak value
and the limit lines.
QPEak - Displays the difference values, in dB, from the measured quasi-peak
value and the limit lines.
AVERage - Displays the difference values, in dB, from the measured average
value and the limit lines.
Factory Preset
and *RST: Not affected by preset
Front Panel
Access:
MEASURE, More, Signal List, Edit List, Comment
MEASURE, More, Signal List, Edit List, Pk Ampl
MEASURE, More, Signal List, Edit List, QP Ampl
MEASURE, More, Signal List, Edit List, AV Ampl
208 Chapter 5