Table of Contents
Advertisement
4.2
Obtain Modem IP Address
Chapter 7. REMOTE CONTROL
If the modem IP Address is known, continue to Section 4.3. Otherwise, do the following:
1. Connect the user PC to the modems serial remote port using the appropriate adapter.
2. Open a terminal emulator application, such as Putty or TeraTerm.
3. Establish a connection to the modem using the appropriate RS232 port configured for
115200 baud, 8 data bits, no parity, and 1 stop bit.
4. Issue the IPA remote command, see Chapter 7. REMOTE CONTROL for command syntax.
5. Open a DOS command window on the user PC and "ping" the modem using the IP Address
returned in step 4. Syntax is "ping xxx.xxx.xxx.xxx".
6. Issue the MIS remote command, see Chapter 7. REMOTE CONTROL for command syntax.
7. If Secure mode is ON, turn it OFF using the MIS command, and reboot the modem.
8. Establish an HTTP connection to the modem using the IP Address returned in step 4.
4.3
Bulk Firmware Update – Ethernet FTP Upload Procedure
Chapter 6. MODEM CONFIGURATION
Refer to Chapter 6. MODEM CONFIGURATION, Section 6.4.2.3 Admin | Upgrade for
instructions on how to upgrade the bulk firmware.
Update Firmware
SLM-5650C / SLM-5650C-ODU Satellite Modem
4–2
Revision 1
MN-SLM-5650C
Advertisement
Table of Contents
Need help?
Do you have a question about the SLM-5650C CyberLynx and is the answer not in the manual?
Questions and answers
does the 5650C have a gui