Install The Realpresence Collaboration Server (Rmx) 4000 As A Standalone System; Mount The Realpresence Collaboration Server (Rmx) 4000 In A Rack - Polycom RealPresence RMX 4000 Hardware Manual

3 Slide out the RTM LAN or RTM ISDN card.
To install a new or replacement RTM ISDN card:
.
1 On the RTM ISDN card move the ejector levers to their fully open position.
2 Push the card into the slot until the ejector levers touch the front edge of the card cage. Push the
ejector levers to their fully closed position.
3 Tighten the captive screws on each side of the rear panel of the card, securing the RTM ISDN card
to the MCU.
Install the RealPresence Collaboration Server (RMX)
4000 as a Standalone System
» Place the RealPresence Collaboration Server (RMX) 4000 on a flat surface or desktop.
The RealPresence Collaboration Server (RMX) 4000 must rest on the four feet at the base of the
MCU and must be shifted or moved into position using the two handles attached to the front.
Mount the RealPresence Collaboration Server (RMX)
4000 in a Rack
Perform the following steps to mount the RealPresence Collaboration Server (RMX) 4000 in a Rack.
Rack Mount Preparations
● Optional. Depending on the rack installed in your site, you may need to remove the handles if they
are attached to the RealPresence Collaboration Server (RMX) 4000.
Polycom, Inc.
Install the RealPresence Collaboration Server (RMX) 4000
32