Removing The Chain Guide Shoe; Removing The Saddle Support - APRILIA RS 50 Workshop Manual

Cycle Parts
RS 50

REMOVING THE CHAIN GUIDE SHOE

2
Read through the section PRECAUTIONS AND
GENERAL INFORMATION.
Remove the swing arm (REMOVING THE SWING
ARM).
Loosen and remove screw (1).
Tightening torque for screw (1):
3 Nm (0.3 kgm) [2.2 ft-lb]
3
Collect cup (2).
1
Remove chain guide shoe (3).

REMOVING THE SADDLE SUPPORT

Read through the section PRECAUTIONS AND
GENERAL INFORMATION.
Remove the fairings (REMOVING THE SIDE
FAIRINGS).
Place the vehicle on the stand.
Remove the rider saddle (REMOVING THE RIDER
SADDLE).
Remove the fuel tank (REMOVING THE FUEL TANK).
Remove the battery (REMOVING THE BATTERY).
Remove the rear fairing with the passenger saddle
7
(REMOVING THE REAR FAIRING).
Remove the saddle support covers (REMOVING THE
SADDLE SUPPORT COVERS).
Remove the passenger footrest supports (REMOV-
ING THE PASSENGER FOOTREST SUPPORTS).
Remove the saddle support lower panel with the
number-plate holder and the rear light (REMOVING
THE SADDLE SUPPORT LOWER PANEL).
Remove the mixer oil reservoir (REMOVING THE
MIXER OIL RESERVOIR).
Cut and remove straps (4) fastening the wiring to the
saddle support.
7
6
IMPORTANT
Have new straps (4) ready for refit-
ting.
5
Detach electrical connection (5) from the fuses.
When refitting, make sure the electrical connection is
properly reattached.
4
Remove fuse-holding rubber (6) with fuses (7).
7-33
chap. 7
Release 00 2000-11