Executive Barge-In; Walking Class Of Service; In/Out Of Group - Samsung DCS-816 Programming Manual

SAMSUNG
DCS-816

1.6 EXECUTIVE BARGE-IN

If you want to break into another station's conversation, you must be allowed to barge-in
and the other station must not be secure.
• Dial the desired extension number and listen for the busy signal.
• Press the BARGE-IN key and begin speaking after the tone.
• Hang up when you are finished.
The system can be set for one of the three following barge-in options:
• No barge-in allowed
• Barge-in with intrusion tone
• Barge-in without intrusion tone (service observing)
When this last option is selected, the station that barges-in can monitor the conversation
and no warning tone or display will be sent to the station being monitored. The handset
transmitter and keyset microphone (if equipped) are disabled. The party that originated the
barge-in may join the conversation by pressing the MUTE key on the keyset.
Your service company must program these options for you.

1.7 WALKING CLASS OF SERVICE

You can change a restricted station's class of service to the same class that your station is
in, allowing you to make calls or use features that would otherwise be restricted from that
station.
•
Lift the handset or press the SPK key.
•
Dial 59 and then your extension number.
•
Dial your station passcode and receive internal dial tone.
•
Dial an access code and then the telephone number -OR-
feature as usual.
•
Hang up. The station will be returned to its restricted status
NOTE: The default station passcode 1234 cannot be used

1.8 IN/OUT OF GROUP

Any station assigned to a station group can leave that group and then reenter the group at
a later time. When out of the group, a station can receive calls to its extension number but
not to the group. There are 10 groups and the access codes are 500-509.
To create a backup or relief operator position, assign the main operator and one or more
backup individuals to the operator group. All but the main operator should be out of the
group. When it is necessary to use a backup operator, put the desired backup station in
the group and remove the main operator. When incoming call traffic is heavy, you can
have another station put itself in the operator group along with the main operator to handle
the extra call load.
If the station does not have an IN/OUT key:
•
Lift the handset and dial 53.
•
Dial the group number.
•
Dial 0 to be out of the group -OR- dial 1 to be in the group.
System Administration and Special Features Guide
1 - 2
February, 1999
use the desired