Samsung DCS-816 Programming Manual page 217

SAMSUNG
DCS-816
MMC: 733
DESCRIPTION:
Used to call up the customer recorded and pre–recorded messages into plans
compiled in MMC 732. Pre–recorded messages listed below can be applied
and destinations can be programmed as required. Specific ports are
programmed by MMC 735, AA Use Table.
There are a total of 64 messages on an AA card:
Attributes are as follows:
ATTR TITLE
0 DAY MSG
1 NIGHT MSG
2 ALTER MSG 01–64
3 INVLID MSG 01–64
4 NO ANS MSG 01–64
5 XFER MSG
6 BUSY MSG
7 NO STN MSG 01–64
8 NO ACT MSG 01–64
9
10 ANS DELAY
11 RETRY CNT
12 TRANS TABLE 01–12
13 BUSY DEST
14 NO ANS DEST DEST
15 NO ACT DEST DEST
16 INVALID DEST DEST
There is a total of 12 tables (01–12) in the system, but not all tables have to
be used.
DESTINATION
ACTION
1. Press TRSF 733
Display shows
2. Dial AA PLAN TABLE number (01 – 12, e.g. 02)
OR
Press UP or DOWN to select and press RIGHT
soft key
– 48 messages are to be recorded by the user (01–48),
– 16 messages are pre–recorded in ROM on the card (49–64).
DATA
01–64
01–64
01–64
01–64
CAMP ON Yes/No
01–10
0–5
DEST
: STATION, STATION GROUP, AA PLAN NO.
AA PLAN TABLE
COMSG
Introduction message during Day Mode
Introduction message during Night Mode
Emergency message
Message when an invalid digit is dialled
Message when there is no reply from the
destination
Transfer notifying message
Message on busy reply
Message on retrial
Message on no action
Allow camp–on to busy extension
Answer Delay
No of times the AA will try to connect before
routing to final destination.
Assigning associated TRANS TABLE
Alternative destination on busy
Alternative destination on no answer
Default destination on no action
Default destination on invalid action
MMC 733 (Page 1 of 2)
Programming
February, 1999
DISPLAY
AA PLAN PROG(01)
DAY MSG : NONE
AA PLAN PROG(02)
DAY MSG : NONE