Samsung DCS-816 Programming Manual page 150

SAMSUNG
DCS-816
MMC: 603
DESCRIPTION:
Allows the assignment of trunks to a specific trunk group or to several trunk
groups. This is very useful in the programming of LCR when more than one trunk
is to be in several dialling plans. There are two different modes of operation: (1)
sequential and (2) distribute.
WARNING
One trunk can appear in more than one trunk group. If necessary, delete the trunk member from
other groups to prevent accidental access.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
ANS/RLS
ACTION
1. Press TRSF 603
Display shows
2. Enter in valid trunk group (e.g., 9, 80–82)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to advance cursor
3. Press RIGHT soft key to change mode
OR
Press UP or DOWN key to change mode to
member
4. Press RIGHT soft key to move cursor to number
of member and enter valid member number (01–
10, e.g., 05) via dial keypad
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to move cursor
5. Enter valid trunk number (e.g., 705)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to return to step 2
6. Repeat steps 1–5 to remove trunk from group 0 if
necessary
ASSIGN TRUNK GROUP
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
Used to select ALL
MMC 603 (Page 1 of 2)
Programming
February, 1999
DISPLAY
[9] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MEMBER 01:NONE
[81] TRK GROUP
MEMBER 05:NONE
[81] TRK GROUP
MEMBER 01:705