Ctm - Cti Module (Tapi) (Figure 6-4) - Samsung DCS-816 Programming Manual

SAMSUNG
DCS-816

6.5 CTM - CTI Module (TAPI) (Figure 6-4)

The DCS CTM module is required to support CTI (TAPI) in the system. The CTM has a DLI
connection and a personal computer (PC) interface, which can be connected to any DLI port of
DCS-816. The system requires MDF connection for CTM modules and modular jack connection
for a keyset. A PC may connect to the module via the DB9 connector. See Figure 2-3 and refer
to section 2.5 (MDF Cabling).
Using one pair twisted wires, connect each CTM module (via the modular jack marked 'DLI IN') to
the DLI port of your choice via the champ connector on the base board and then connect the
module (via the other modular jack marked 'KTS OUT') to a keyset. A PC can be connected to
the module via the DB9 connector.
A special PC software package is required to run CTI (TAPI) and how to set up the software is
described in the other document in detail. Contact your dealer for information.
25 PAIR CABLE WITH FEMALE CONNECTOR TO THE BASE CHAMP CONNECTOR
KTS OUT
RS-232-C(DB-9)
CONNECTING A CTM (TAPI)
CHAMP CONNECTION
PIN COLOUR
39/14 BK-BR/ BR/BK T/R, 1
40/15 BK-S/ S-BK
41/16 Y-BL/ BL-Y
42/17 Y-O/ O-Y
43/18 Y-GR/ GR-Y
44/19 Y-BR/ BR-Y
45/20 Y-S/ S-Y
46/21 VL-BL/BL-VL
47/22 VL-O/ O-VL
48/23 VL-GR/ GR-VL T/R, 10
49/24 VL-BR/ BR-VL T/R, 11
50/25 VL-S/ S-VL
PIN ASSIGNMENT
CTM
TXD 2
RXD 3
GND 5
DLI IN
² CONNECT A CTM TO ANY DLI PORT
² YOU
OUTDOORS
² SPECIAL PC SOFTWARE REQUIRED
CIRCUITS/ FUNCTIONS
T/R, 2
T/R, 3
T/R, 4
T/R, 5
T/R, 6
T/R, 7
T/R, 8
T/R, 9
T/R, 12
PC
COM1 COM2
2 3 (RxD)
3 OR 2 (TxD)
5 7 (GND)
9 PIN 25 PIN
CANNOT INSTALL
6-5
Installation
February, 1999
st
DLI port on base
nd
DLI port on base
rd
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
THE EQUIPMENT
FIGURE 6-4