Executive Barge-In; Walking Class Of Service; In/Out Of Group - Samsung DCS-816 System Administration And Special Features Manual

SAMSUNG
DCS-816

1.4 EXECUTIVE BARGE-IN

If you want to break into another station's conversation, either to monitor the call or join
the conversation, your keyset must be programmed to allow you to barge in, and the other
station(s) must not be secured against barge in. These options must be programmed for
you by the system installer; you do not have customer-level access to the relevant pro-
gram. You can then select one of the following barge-in options for your keyset (see MMC
206):
• No barge-in allowed
• Barge-in with tone
• Barge-in without tone
Barging in on an unsecure station can be done with or without an intrusion tone or display.
If 'with tone' is selected, a warning tone and display will be sent to the station. If 'without
tone' is selected, the station that barges-in can monitor the conversation and no warning
tone or display will be sent to the station being monitored. The handset transmitter and
keyset microphone of the barging-in station are disabled. You can, however, join the con-
versation by pressing the MUTE key on the keyset to enable the handset and microphone.
To barge in:
1. Dial the desired extension number and listen for the busy signal.
2. Press the BARGE key. (If joining the conversation, also press the MUTE key and
begin speaking after the tone).
3. Hang up when you are finished.
Note: You can investigate to see what number is calling a station, or is being called, before you
barge in. See Investigate (ISPY) in the CLIP Special Features section (Part 2) of this guide.

1.5 WALKING CLASS OF SERVICE

You can change a restricted station's class of service to the same class that your station is
in, allowing you to make calls or use features that would otherwise be restricted from that
station.
Lift the handset or press the SPEAKER key.
•
Dial 59 and then your extension number.
•
Dial your station passcode
•
Dial an access code and then the telephone number -OR- use the desired feature
•
as usual.
Hang up. The station will be returned to its restricted status.
•
1
NOTE: You must change the station passcode from the default 1234 first.

1.6 IN/OUT OF GROUP

Any station assigned to a station group can leave that group and then reenter the group
later. When out of the group, a station can receive calls to its extension number but not to
the group. There are 10 groups and the access codes are 500-509.
System Administration and Special Features Guide
1
and receive internal dial tone.
1 - 2
March 1999