Samsung DCS-816 Programming Manual page 223

SAMSUNG
DCS-816
MMC: 800
DESCRIPTION:
Used to open and close technician–level programming. If programming is not
opened and an attempt is made to access a system MMC, the error message
"ACCESS DENIED" will be displayed.
A four digit passcode is required to access this MMC. Each character can be
digits 0–9. When opened, this MMC enables access to all MMCs.
When the system was installed, the Country Code should have been selected
using MMC 812 before any other programming was done. If this is not the
case, MMC 800 will require the installer to enter the code before continuing.
After selecting the code, the system restarts and all default data are changed
to new data for the selected country.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
ACTION
1. Press TRSF 800
Display shows
2. Enter passcode
Correct code shows
Incorrect code shows
ENABLE TECHNICIAN
PROGRAM
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
MMC 800 (Page 1 of 2)
Programming
February, 1999
DISPLAY
ENABLE TECH.PROG
PASSCODE:
ENABLE TECH.PROG
PASSCODE: QQQQ
ENABLE TECH.PROG
DISABLE
ENABLE TECH. PROG
PASSCODE ERROR