Samsung DCS-816 Programming Manual page 141

SAMSUNG
DCS-816
MMC: 508
DESCRIPTION:
Allows the system administrator to set the Call Cost attributes generated by the
system during a call. This information can be displayed on the keyset LCD during a
call or as an SMDR record.
Attributes are as follows:
0 UNIT COST PER MP
1 CALL COST RATE
WARNING
• Changing this value when there is a call in progress may result in an inaccurate
• This MPD facility requires the Meter Pulse Detection version of the trunk card. It
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
ACTION
1. Press TRSF 508
Display shows
2. Dial 0 or 1 (e.g. 1)
OR
Press UP or DOWN key for selection and press
RIGHT soft key to move cursor
3. Enter new value (e.g. 110 for 110 percent)
System returns to step 2
4. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC
call cost.
is not available on the standard product.
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
When the system is installed to receive MP on a C.O.
outgoing call. It is used for generating total call cost by
multiplying it by the number of pulses. Allows a
maximum value of 5000.
This generates additional call cost calculated by
multiplying this rate by the original call cost. Ranges
from 100 through 255.
MMC 508 (Page 1 of 2)
Programming
February, 1999
CALL COST
DISPLAY
UNIT COST PER MP
0200 PENCE→
CALL COST RATE
100% →_
CALL COST RATE
110% →