Danfoss AK2-SC 255 Reference Manual page 85

84
Humidity adjusts target:
Humidity sensor
Dynamic offset
No offset <
Full >
Ambient temp lockout
No cooling below
Night setback
Night setback offset
Minimum ON time
Minimum OFF time
AK2-SC 255 Reference Manual
(List box: Yes, No) Whether or not humidity will adjust
the cooling target temperature.
(List box:)
Average: Cooling target modification will be based on
an average of two humidity sensors.
High: Cooling target modification will be based on the
highest of two humidity sensors.
Zone 1(etc.): (each zone humidty sensor will be
available as a choice in the list) Cooling target modifi-
cation will be based on the single selected sensor.
(-99.9 to 99.9) The number of degrees by which
humidity can adjust the target temperatures. Within the
range of humidity limiting the offset, a linear relation-
ship will exist between humidity and offset. (see also
next two parameters).
(-99.9 to 99.9) The relative humidity below which
there will be no offset of target temperature.
(-99.9 to 99.9) The relative humidity above which the
maximum offset of target temperature by humidity will
be applied.
(List box: Yes, No) Whether or not cooling is to be
locked out below a set ambient temperature (next line).
(0.0 to 100.0) The ambient temperature below which
cooling will be locked out.
(List box: Yes, No) Whether or not the cooling
setpoints are to be raised by an offset (next line) when
the store is closed according to a schedule or schedules
configured in the Store Info screens.
(-50.0 to 50.0) The amount by which the cooling
setpoint (set on previous page) is to be raised during
store closed hours (as set in the Store Info screen.
(0 to 60) The minimum number of minutes cooling
must run after being turned on before being turned off.
(0 to 60) The minimum number of minutes cooling
must remain off after being turned off before being
turned on.
RS.8D.M1.22