Messages Screen - Danfoss AK2-SC 255 Reference Manual

Messages
186
Baud:
Type:
Init:
Date:
Time:
Schedules:
Date:
Language
Send alarms when cleared? (List box, Yes, No. Default: No) If "Yes" is
Time:
Schedules:
By selecting Messages from the Communications menu, a messages screen appears:
AK2-SC 255 Reference Manual
AKC 55 between dialouts to this number. Default
is 10 minutes. This value should not be set to less
than 3 minutes except by a service technician on
site with the AKC 55 for diagnostic purposes. If
the delay is too short, there are situations when
the AKCESS system may dial out alarms so
frequently that it is not possible to dial IN to the
system.
— The baud rate of the receiving station. The rate
can be set to 300, 1200, 2400, 9600, 14400, 28800,
or AUTO. The default is AUTO, which will auto-
detect the receiving station modem rate. For most
purposes it is best to set the Baud field to Auto.
— The type of receiving device, either Printer or
AKA 65.
— An extra initialization string which may be needed
for some modes of communication. Default is AT.
The entry is user-editable.
— The date format: DD/MM/YY, DD/MM/YYYY,
MM/DD/YY, or MM/DD/YYYY.
— The time format, either 12 hour or 24 hour.
— The schedule for dialouts to this phone number.
— The date format: DD/MM/YY, DD/MM/YYYY,
MM/DD/YY, or MM/DD/YYYY.
--- (List box) Allows language selection for transmited
alarms.
selected, The designated monitoring station will be
sent alarms when a previously reported alarm has
cleared.
— The time format, either 12 hour or 24 hour.
— The schedule for dialouts to this phone number.
RS.8D.M1.22