Connect Usb Host; Connect Usb Client; Connect Serial Device - Honeywell THOR VM1 User Manual

Connect USB Host

Host / Client Y Cable
D9 Connector
See USB Connector
1. Seat the D9 connector firmly over the USB connector on the dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB-host connector provides a connector for a USB device such as a USB thumb drive.
4. Secure the cables to the Thor VM1 with

Connect USB Client

Note: The USB client connection is not used on Thor VM1 with a Windows Embedded Standard operating system.

Connect Serial Device

Note: Pin 9 of the COM port is configured to provide +5V.
See COM1 and COM2 Connector
1. Seat the cable end connector firmly over the serial COM port on the dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Secure the cables to the Thor VM1 with
4. Connect the other cable end to the desired serial device.
Connect a Tethered Scanner
1. The scanner cable is attached to either the COM1 or COM2 port on the dock.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM1 is powered on, it provides power to the serial scanner.
4. Configure the Data Collection (DC) Wedge to manipulate scanned data as desired.
4 - 52
USB Host Connector
USB Client Connector
(page 8-6) for connector pinouts.
Strain Relief Cable Clamps
(page 8-5) for connector pinouts.
Strain Relief Cable Clamps
(page 4-29).
(page 4-29).