Connect USB Host
Host / Client Y Cable
D9 Connector
See
USB Connector
(page 8-6) for connector pinouts.
1. Seat the D9 connector firmly over the USB connector on the dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB-host connector provides a connector for a USB device such as a USB thumb drive.
4. Secure the cables to the Thor VM2 with
Connect USB Client
Note: The USB client connection is not used on the Thor VM2 with a Windows 7, Windows Embedded Standard or Windows
Embedded 7 operating system.
Connect Serial Device
Note: Pin 9 of the desired COM port must be configured to provide +5V or RI as needed for the connected device. See the
Options
(page 5-19) control panel for details.
See
COM1 and COM2 Connector
1. Seat the cable end connector firmly over the serial COM port on the dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Secure the cables to the Thor VM2 with
4. Connect the other cable end to the desired serial device.
Connect a Tethered Scanner
1. The scanner cable is attached to either the COM1 or COM2 port on the dock.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM2 is powered on, it provides power to the serial scanner.
4. Configure the Data Collection (DC) Wedge to manipulate scanned data as desired.
USB Host Connector
USB Client Connector
Strain Relief Cable Clamps
(page 8-5) for connector pinouts.
Strain Relief Cable Clamps
(page 4-16).
(page 4-16).
4 - 41