Boost Pressure Sensor - Remove And Install - Perkins 1106D Disassembly And Assembly

164
Disassembly and Assembly Section
Illustration 334
1. Position a new sealing washer (4) on the fuel
pressure sensor (3).
2. Remove the plug from the fuel manifold.
3. Use a deep socket to install the fuel pressure
sensor (3) to the fuel manifold. Tighten the fuel
pressure sensor to a torque of 34 N·m (25 lb ft).
4. Connect the harness assembly (2) to the fuel
pressure sensor (3).
5. Slide the locking tab (1) into the locked position.
6. Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, "Fuel System
- Prime".
Boost Pressure Sensor -
Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01175003
Illustration 335
1. Slide the locking tab (1) into the unlocked position.
2. Disconnect the harness assembly (2) from the
boost pressure sensor (3).
Note: The boost pressure sensor has a three-wire
plug.
3. Use a deep socket to remove the boost pressure
sensor (3) from the inlet manifold.
4. Remove the O-ring seal (4) from the boost
pressure sensor (3).
5. Discard the O-ring seal.
Installation Procedure
i02296728
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
SENR9983
g01160297
NOTICE