Perkins 1106D Disassembly And Assembly page 87

SENR9983
b. Remove the water pump. Refer to Disassembly
and Assembly Manual, "Water Pump - Remove".
Note: In order to remove the front cover, it is not
necessary to remove the crankshaft pulley or the
alternator.
Illustration 159
Typical example
1. Remove the M8 setscrews (3) and (4). Remove
the M10 setscrew (5). Identify the positions of the
different setscrews.
Note: The M10 setscrew (5) may not be installed to
some engines.
2. Remove the front cover (1) from the front housing.
3. Remove the joint (2) from the front cover (1).
Discard the joint.
Installation Procedure
Table 38
Required Tools
Part
Tool
Number
Guide Stud
-
A
(M8 by 70 mm)
g01156385
Part Name Qty
2
Disassembly and Assembly Section
Illustration 160
Typical example
1. Thoroughly clean the joint face of the front
housing.
2. If the original front cover is installed, follow Steps
2.a through 2.b.
a. Thoroughly clean the front cover (1).
b. Install a new joint (2) to the front cover (1).
Engage the three locators (Y) into the holes
in the front cover.
3. Install Tooling (A) into holes (X) in the front
housing.
4. Use Tooling (A) in order to position the front cover
assembly onto the front housing.
5. Install the M8 setscrews (3) and (4). Install the
M10 setscrew (5) finger tight. Ensure that the
different setscrews are installed in the correct
positions.
Note: The M10 setscrew (5) may not be installed to
some engines.
6. Loosely install the water pump assembly and
remove Tooling (A). Refer to Disassembly and
Assembly Manual, "Water Pump - Install" for the
correct procedure.
87
g01172809