Perkins 1106D Disassembly And Assembly page 160

160
Disassembly and Assembly Section
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting, and repair of the product. Be prepared
to collect the fluid with suitable containers before
opening any compartment or disassembling any com-
ponent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the coolant from the cooling system, to a
level below the coolant temperature sensor, into
a suitable container for storage or for disposal.
Refer to Operation and Maintenance Manual,
"Cooling System Coolant - Change" for the correct
draining procedure.
Illustration 327
2. Slide the locking tab (1) into the unlocked position.
3. Disconnect the harness assembly (2) from the
coolant temperature sensor (3).
4. Use a deep socket in order to remove the coolant
temperature sensor (3) from the cylinder head.
5. Remove the O-ring seal (4) from the coolant
temperature sensor (3).
6. Discard the O-ring seal.
Installation Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 328
1. Lubricate a new O-ring seal (4) with clean engine
oil. Install the new O-ring seal onto the coolant
temperature sensor (3).
2. Use a deep socket in order to install the coolant
temperature sensor (3) to the cylinder head.
Tighten the coolant temperature sensor to a
torque of 15 N·m (11 lb ft).
g01159987
3. Connect the harness assembly (2) to the coolant
temperature sensor (3).
4. Slide the locking tab (1) into the locked position.
5. Fill the cooling system to the correct level. Refer
to Operation and Maintenance Manual, "Cooling
System Coolant Level - Check" and refer to
Operation and Maintenance Manual, "Cooling
System Coolant - Test/Add" for the correct filling
procedure.
SENR9983
NOTICE
g01159987