Perkins 1106D Disassembly And Assembly page 107

SENR9983
Illustration 211
2. Ensure that all components of the crankcase
breather are clean and free from damage. Replace
any components that are damaged.
3. Lubricate a new O-ring seal (9) with clean engine
oil. Install the O-ring seal to the adapter plate (8).
4. Install the adapter plate (8) to the valve mechanism
cover (10).
5. Install the washers (7) and the two setscrews (6)
to the adapter plate (8). Tighten the setscrews to
a torque of 4.4 N·m (38 lb in).
6. Lubricate a new O-ring seal (5) with clean engine
oil. Install the O-ring seal to the bottom of the
breather body (4).
7. Use Tooling (A) in order to screw the breather
body (4) into the adapter plate (8). Tighten the
breather body to a torque of 8 N·m (71 lb in).
8. Install the gauze (2) into the breather body (4).
9. Lubricate a new O-ring seal (3) with clean engine
oil. Install the O-ring seal to the top of the breather
body (4).
10. Install the cover (1) to the breather body (4).
Note: Ensure that the outlet of the cover is in the
correct position in order to align with the hose (15)
for the breather.
Illustration 212
11. Install the two setscrews (17) to the base (18).
If a spacer is installed, position the spacer (16)
to the setscrews.
12. Install the assembly of the base to the inlet
g01200785
manifold (not shown).
13. Tighten the setscrews (17) to a torque of 22 N·m
(16 lb ft).
14. Install a new canister (20) to the base (18).
Refer to Operation and maintenance Manual,
"Crankcase Breather (Canister) - Replace".
15. Install the spring clamps (14) to the hose (15).
Install the hose (15) to the cover (1) and to the
base (18).
Note: Ensure that the spring clamps are correctly
positioned in order to secure the hose.
16. Install the clamp (19) to the hose (21). Install the
hose (21) to the base (18). Tighten the clamp.
Disassembly and Assembly Section
107
g01200786