Fuel Injection Pump Gear - Install - Perkins 1106D Disassembly And Assembly

SENR9983
Illustration 34
4. Apply sufficient pressure to the fuel injection pump
gear (3) in a counterclockwise direction in order
to remove the backlash. Lock the fuel injection
pump (5) in this position.
In order to lock the fuel injection pump (5), loosen
the locking screw (6) in the fuel injection pump.
Slide the spacer (7) into position (Z). Tighten the
locking screw (6) against the shaft of the fuel
injection pump to a torque of 9 N·m (80 lb in).
Illustration 35
Alignment of timing marks
5. Mark the gears (1), (2) and (3) in order to show
alignment. Refer to Illustration 35.
Note: Identification will ensure that the gears can be
installed in the original alignment.
Illustration 36
6. Loosen the nut (8) for the fuel pump gear (3).
7. Install Tooling (D) through two opposite holes in
the fuel pump gear (3). Tighten Tooling (D) until
the fuel pump gear (3) is released.
g01196435
8. Remove Tooling (D) from the fuel pump gear (3).
9. Remove the nut (8) and washer (not shown) from
the fuel pump gear (3). Remove the fuel pump
gear.
Fuel Injection Pump Gear -
Install
Installation Procedure
Table 6
Tool
B
C
g01196142
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: The fuel injection pump must remain locked
until the procedure instructs you to unlock the fuel
injection pump.
1. Ensure that number one piston is at top dead
center on the compression stroke. Refer to the
Testing and Adjusting Manual, "Finding Top Center
for No. 1 Piston".
Disassembly and Assembly Section
Required Tools
Part
Part Name
Number
27610212
Camshaft Timing Pin
27610286
Crankshaft Timing Pin
NOTICE
23
g01196132
i02296767
Qty
1
1