Perkins 1106D Disassembly And Assembly page 74

74
Disassembly and Assembly Section
Illustration 132
Alignment tool
1. To install the crankshaft rear seal without the
isolating frame for the oil pan in position, Tooling
(B) must be used. The tool should be fabricated
from 8 mm (5/16 inch) steel stock. The dimensions
for the tool are given in Illustration 132. All
dimensions are shown in millimeters.
Illustration 133
2. Ensure that the crankshaft palm (1) is clean, dry
and free from damage. If the crankshaft palm
is worn or damaged, install a crankshaft wear
sleeve. Refer to Disassembly and Assembly
Manual, "Crankshaft Wear Sleeve (Rear) -
Remove and Install".
3. Ensure that the mating face of the cylinder block
is clean and dry.
4. Ensure that the plastic sleeve (3) is squarely
installed within the new crankshaft rear seal (2).
Note: The plastic sleeve (3) is included in order
to protect the lip of the seal as the crankshaft rear
seal is pushed over the crankshaft palm (1). Do not
attempt to install a crankshaft rear seal without the
plastic sleeve.
g01201564
SENR9983
g01183431