Alternator Belt - Remove And Install - Perkins 1106D Disassembly And Assembly

SENR9983
Illustration 340
1. Ensure that the threads of the glow plugs are clean
and free from damage. Replace any damaged
glow plugs.
2. Install the glow plugs (4) into the cylinder head.
Tighten the glow plugs to a torque of 15 N·m
(132 lb in).
3. Position the bus bar (1) onto the glow plugs (4).
Install the six nuts (2) onto the glow plugs. Tighten
the nuts to a torque of 2 N·m (17 lb in).
4. Connect the wire (5) to the stud on the terminal
insulator (6).
5. Install the nut (3) to the stud on the terminal
insulator (6). Tighten the nut to a torque of 6 N·m
(53 lb in).
6. Connect the breather hose to the crankcase
breather (not shown). Refer to Disassembly and
Assembly Manual, "Crankcase Breather - Install".
7. Restore the electrical supply to the engine.
Alternator Belt - Remove and
Install
Removal Procedure
Table 78
Tool
A
1. If the engine has fan guards, remove the fan
guards.
g01172800
Illustration 341
2. Install a suitable square drive tool into hole (X) in
the tensioner (3). From the front of the engine,
turn the tool in a clockwise direction.
3. Insert Tooling (A) into hole (Y). Release the
pressure on the square drive tool.
4. Remove the alternator belt (1).
Note: Mark the direction of rotation if the belt will
be reused.
5. From the front of the engine, turn the square drive
tool in a clockwise direction. Release the pressure
on Tooling (A). Remove Tooling (A) from hole (Y).
6. Release the pressure on the square drive tool and
remove the tool from hole (X).
Disassembly and Assembly Section
Required Tools
Part Part Description
Number
Locking Pin
-
(Ø 8mm by 85 mm)
167
i02296810
Qty
1
g01156850