Engine Oil Relief Valve - Remove And Install - Perkins 1106D Disassembly And Assembly

SENR9983
Illustration 110
Tightening sequence for an engine oil cooler with a high mounted
oil filter base
3. If the engine has a low mounted oil filter base or a
blanking plate, tighten the setscrews to a torque
of 22 N·m (16 lb ft) in the sequence that is shown
in Illustration 109.
If the engine has a high mounted oil filter base,
tighten the setscrews to a torque of 22 N·m
(16 lb ft) in the sequence that is shown in
Illustration 110. Tighten the remaining setscrews
that secure the oil filter base to a torque of 22 N·m
(16 lb ft).
4. Remove the plugs from the tube assembly (9).
Remove the caps for the fuel return from the
cylinder head and from the transfer pump (8).
Install the tube assembly (9) to the cylinder head
and to the transfer pump (8).
5. Follow Steps 5.a through 5.e in order to connect
the engine wiring harness (4).
a. Place the harness in position.
b. Connect the engine wiring harness (4) to the
position sensor (2) for the fuel injection pump.
c. Connect the engine wiring harness (4) to the oil
pressure sensor (13).
d. Connect the engine wiring harness (4) to the
solenoid (1) for the fuel injection pump.
e. Install new cable ties in order to secure the
engine wiring harness (4) to the assembly of
the oil cooler (6).
6. Remove the plugs from all plastic tube assemblies
(3). Remove the caps from the appropriate ports.
Install the plastic tube assemblies (3).
7. If the engine has a low mounted oil filter on the
left hand side, install the oil filter base. Refer to
Disassembly and Assembly Manual, "Oil Filter
Base - Remove and Install".
If the engine has a right hand side oil filter, follow
Steps 7.a through 7.d in order to install the
blanking plate (12).
a. Install the four setscrews (11) to the blanking
plate (12).
b. Position a new joint (not shown) onto the
blanking plate (12).
c. Install the assembly of the blanking plate to the
assembly of the oil cooler (6).
d. Tighten the setscrews (11) to a torque of
22 N·m (16 lb ft).
g01180321
8. Fill the cooling system to the correct level. Refer
to Operation and Maintenance Manual, "Cooling
System Coolant - Fill" for the correct procedure.
9. Check the level of the engine lubricating oil. Refer
to Operation and Maintenance Manual, "Engine
Oil Level - Check" for the correct procedure.
End By:
a. Install the bracket for the Electronic Control
Module. Refer to Disassembly and Assembly
Manual, "ECM Bracket - Remove".
Engine Oil Relief Valve -
Remove and Install
Removal Procedure
Start By:
a. Remove the engine oil pan. Refer to Disassembly
and Assembly Manual, "Engine Oil Pan -
Remove".
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Disassembly and Assembly Section
NOTICE
61
i02296785