Connecting Rod Bearings - Remove (Connecting Rods In Position) - Perkins 1106D Disassembly And Assembly

SENR9983
Note: Ensure that the etched number (X) on
connecting rod cap (2) matches the etched number
(X) on connecting rod (1). Ensure the correct
orientation of the connecting rod cap (2). The locating
tab for the upper bearing shell and the lower bearing
shell should be on the same side.
7. Install two new setscrews (3) to the connecting
rod (1). Tighten the setscrews evenly to a torque
of 18 N·m (13 lb ft).
Note: Do not reuse the old setscrews in order to
secure the connecting rod cap.
8. Tighten the setscrews evenly to a torque of
70 N·m (52 lb ft).
9. Turn the setscrews for an additional 120 degrees.
Use Tooling (C) to achieve the correct final torque.
10. Ensure that the installed connecting rod assembly
has tactile side play. Rotate the crankshaft in order
to ensure that there is no binding.
11. Repeat Steps 2 through 10 in order to install the
remaining pistons and connecting rods.
12. Check the height of the pistons above the top
face of the cylinder block. Refer to Testing and
Adjusting Manual, "Piston Height - Inspect" for the
correct procedure.
End By:
a. Install the piston cooling jets. Refer to Disassembly
and Assembly, "Piston Cooling Jets - Remove
and Install".
b. Install the engine oil pump. Refer to Disassembly
and Assembly, "Engine Oil Pump - Install".
c. Install the cylinder head. Refer to Disassembly
and Assembly, "Cylinder Head - Install".
Disassembly and Assembly Section
Connecting Rod Bearings -
Remove
(Connecting rods in position)
Removal Procedure
Table 70
Required Tools
Tool Part Number
21825576
A Crankshaft Turning Tool
27610289
Crankshaft Turning Tool
A
27610290
Gear
Start By:
a. Remove the engine oil pump. Refer to
Disassembly and Assembly Manual, "Engine Oil
Pump - Remove".
Note: Either Tooling (A) can be used. Use the Tooling
that is most suitable.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Discard all used Connecting Rod fasteners.
1. Use Tooling (A) to rotate the crankshaft until the
crank pin is at the bottom center position.
145
i02296697
Part Description Qty
1
1
1