Engine Oil Pump - Install - Perkins 1106D Disassembly And Assembly

64
Disassembly and Assembly Section
6. If necessary, remove the allen head screws (6)
and the front cover assembly (7). Remove the
outer rotor (8) from the housing of the engine oil
pump (4).
Note: Do not remove the dowels (9) from the
housing of the engine oil pump unless the dowels
are damaged.

Engine Oil Pump - Install

Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
If any part of the engine oil pump is worn or damaged,
the complete assembly of the engine oil pump must
be replaced.
1. Ensure that all components of the engine oil pump
are clean and free from wear or damage. Refer
to Testing and Adjusting Manual, "Engine Oil
Pump - Inspect" for more information. Replace the
complete assembly of the engine oil pump if any
of the components are worn or damaged.
Illustration 115
Typical example
2. If necessary, install the pressure relief valve (5).
Refer to Disassembly and Assembly Manual,
"Engine Oil Relief Valve - Remove and Install" for
further information.
i02296126
Illustration 116
3. If necessary, lubricate the internal components for
the assembly of the engine oil pump with clean
engine oil. Install the outer rotor (8) and the front
cover (7) to the housing of the engine oil pump
(4). Install the allen head screws (6). Tighten the
allen head screws to a torque of 22 N·m (16 lb ft).
4. Ensure that the two dowels (9) are correctly
located in the housing of the engine oil pump (4).
Position the assembly of the engine oil pump onto
the cylinder block.
Note: Ensure that the dowels in the housing of the
engine oil pump are aligned with the holes in the
cylinder block.
5. Install the setscrews (3). Tighten the setscrews to
a torque of 22 N·m (16 lb ft).
6. Check the backlash between the idler gear (10)
and the crankshaft gear. Refer to Specifications
Manual, "Gear Group (Front)" for further
information.
7. Install the suction pipe (2) and a new joint (not
shown) to the assembly of the engine oil pump.
8. Install the setscrews (1). Tighten the setscrews to
a torque to 22 N·m (16 lb ft).
9. If the suction pipe has a support bracket follow
g01158368
Steps 9.a through 9.c.
SENR9983
g01160744